66 31 006 Removing and installing/replacing ACC sensor (build date from 03/2005)

WARNING: This page is about a different car, the 2008 BMW 760Li, 2007 BMW 760Li, 2006 BMW 760i, 2006 BMW 760Li, and 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 317

Necessary preliminary tasks:

Remove trim grille for bumper trim sideways.

IMPORTANT: Secure ACC sensor (2) against falling out.

Cover bumper in working area (1) with adhesive tape.

Using special tool 00 9 317, unclip ACC sensor (2) from holders on both sides.

Installation:

ACC sensor must be felt and heard to snap into place.

Fig 1: ACC Sensor, Special Tool (00 9 317) And Cover Bumper

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Secure ACC sensor (1) against falling out.

Disconnect plug connection (2) and remove sensor (1).

Fig 2: Plug Connection And ACC Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Adjusting ACC sensor
Carry out programming/coding

Fig 3: ACC Sensor, Adjusting Screws And Height Dimensions
Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out rough adjustment of ACC sensor (1) at adjusting screws (2).

Measurement A [mm]: 42.5 to 43.5