65 24 020 Removing and Installing Or Replacing Blocking Circuit

WARNING: This page is about a different car, the 2006 BMW 760i, 2005 BMW 760i, and 2004 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove trim on C-pillar at bottom right . See 51 43 230 REMOVING AND INSTALLING/REPLACING TRIM ON C-PILLAR AT BOTTOM LEFT OR RIGHT and 51 43 245 REMOVING AND INSTALLING/REPLACING TRIM ON C-PILLAR AT BOTTOM (WITH ELECTRIC REAR SEAT ADJUSTMENT) ON LEFT OR RIGHT .

NOTE: For purposes of clarity, the illustration shows the panel for the rear parcel shelf removed.

Disconnect plug connections (1).

Release screw (2) and remove blocking circuit (3) in direction of arrow from rear window antenna amplifier.

Fig 1: Removing Blocking Circuit & Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure guide pin (1) of blocking circuit (2) is correctly seated in bore in rear window antenna amplifier.

Fig 2: Identifying Guide Pin Of Blocking Circuit

Courtesy of BMW OF NORTH AMERICA, INC.