63 21 186 Removing and Installing/Replacing Rear Light (On Center Of Rear Lid)

WARNING: This page is about a different car, the 2006 BMW 760i, 2005 BMW 760i, and 2004 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

Lever out covers (1) at bottom and remove.

Fig 1: Removing Covers

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE:

Releasing rear light is shown on left side.

Releasing rear light on right side is done in same way.

Unfasten plug connection (1) and disconnect.

Unscrew nuts (2).

Fig 2: Identifying Plug Connection & Nut

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE:

Secure rear light against falling out.

Lower luggage compartment lid.

NOTE: If necessary, secure shims under rear light (1) against falling out.

Pull out rear light (1) slightly in direction of arrow.

Disconnect plug connection underneath and remove rear light (1).

Installation:

Make sure gap is uniform all round between rear light (1) and luggage compartment lid (2).

Make sure sealing frame for rear light is correctly seated; replace if necessary. See 63 21 107 REPLACING SEALING FRAME FOR REAR LIGHT (ON CENTRE OF REAR LID)

Fig 3: Pulling Out Rear Light

Courtesy of BMW OF NORTH AMERICA, INC.

WARNING: Follow instructions for handling light bulbs (exterior lights) . See 63 99 ... INSTRUCTIONS FOR HANDLING LIGHT BULBS (EXTERIOR LIGHTS)

Replacement:

If necessary, remove bulbs.