61 71 061 Replacing Fluid Reservoir For Windshield Washer System

WARNING: This page is about a different car, the 2006 BMW 760i, 2005 BMW 760i, and 2004 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

Remove front underbody protection.

Partially remove front left wheel arch trim.

Remove bottom left cover.

NOTE: Washer fluid will escape when the windshield washer pump is pulled out. Have a suitable container and cleaning cloth ready. Observe filling capacities of fluid reservoir.

Remove level switch for windshield washer system, windshield washer pump and if necessary washer pump of headlight cleaning system from fluid reservoir and set to one side.

NOTE: Lines remain connected.

Pull filler channel (1) out of fluid reservoir (3).

Installation:

Replace sealing ring on filler channel (1).

Detach vent hose (2) from fitting on fluid reservoir (3).

Fig 1: Identifying Filler Channel And Fluid Reservoir

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Release nut (2) and remove fluid reservoir (3) towards bottom.

Installation:

Tightening torque (screws and nuts) = 5 Nm.

Fig 2: Identifying Nut And Fluid Reservoir

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace sealing rings and strainers of washer pumps.

Coat sealing rings of washer pumps with antiseize agent.

Lay washer pump lines without kinks and clip into holders on fluid reservoir.

Fill fluid reservoir for windshield washer system.

Observe filling capacities.