51 21 302 Removing and Installing/Replacing Chrome Strip For Window Cavity Cover Strip (On Outside Of Front Door)

WARNING: This page is about a different car, the 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 311

Attach adhesive tape (1) below window cavity cover strip (2) (risk of damage).

Fig 1: Identifying Window Cavity Cover Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Using special tool 00 9 311 beginning at rear (1) proceeding to front (2), lever out window cavity cover strip.

Fig 2: Identifying Special Tool (00 9 311)

Courtesy of BMW OF NORTH AMERICA, INC.

Pull window cavity cover strip (1) out of mirror (2) in direction of arrow and remove.

Installation:

Moisten window cavity cover strip (1) with water.

Window cavity cover strip (1) must be flush at rear to door edge.

Fig 3: Pulling Window Cavity Cover Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Seal (1) must be correctly fitted in chrome strip (2).

Initialize power window. See 67 62 ... NOTES ON INITIALIZING POWER WINDOW

Fig 4: Identifying Seal

Courtesy of BMW OF NORTH AMERICA, INC.