51 21 170 Removing and Installing or Replacing Outside Handle From Left or Right Front Door

Special tools required: 

• 00 9 318 
• 51 3 251 
• 51 3 252 

Lever out plugs (1 and 2) with special tool 00 9 318  .

Tape off area around bore and door seal with fabric adhesive tape (risk of damage).

Installation: 

If necessary, fit new plugs.

Fig 1: Identifying Lever Out Plugs

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool 51 3 251  edgeways behind lockplate (1) (outside of door) and push forwards as far as it will go.

Fig 2: Identifying Special Tool (51 3 251)

Courtesy of BMW OF NORTH AMERICA, INC.

Unlocking outside door handle:

• Feed special tool 51 3 252  into hole (1) of lockplate (2).
• Slide lockplate (2) (if necessary with a short knock) forwards with special tool 51 3 252  .

Installation: 

Insert special tool 51 3 252  into hole (1) of lockplate (2) and pull towards rear as far as it will go.

Perform function check:

• Push lockplate (2) forwards again slightly until resistance can be felt.
  Fig 3: Identifying Special Tool (51 3 252)

  Courtesy of BMW OF NORTH AMERICA, INC.
• Outside door handle must be locked.

Lever out outside door handle at bottom towards top and pull out at an angle towards bottom.

Fig 4: Pulling Door Handle

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, cover outside of door.

Detach clip (1) and remove fiber optics cable (2) from outside door handle.

If necessary, disconnect further plug connection.

Fig 5: Detaching Clip & Fiber Optics Cable

Courtesy of BMW OF NORTH AMERICA, INC.