37 14 610 Removing and Installing/Replacing Transversal-Acceleration Sensor

WARNING: This page is about a different car, the 2008 BMW 760Li and 2007 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection) . See 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

IMPORTANT: Do not kink floor panelling under any circumstances!

Necessary preliminary tasks:

Remove right front seat . See 52 14 000 REMOVING AND INSTALLING LEFT OR RIGHT FRONT SEAT (NORMAL/ELECTRIC) and/or 52 17 000 REMOVING AND INSTALLING LEFT OR RIGHT FRONT SEAT (COMFORT) .
Remove front (inside) entrance cover strip . See 51 47 000 REMOVING AND INSTALLING/REPLACING ENTRANCE COVER STRIP, FRONT (INSIDE) LEFT OR RIGHT .
Lift floor panelling and fold back to one side

Release expansion rivets (1).

Slide air duct to one side until transversal acceleration sensor is exposed.

Fig 1: Releasing Expansion Rivets

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 37 14 23AZ . See 37 14 ELECTRIC COMPONENTS .

Remove transversal acceleration sensor.

Disconnect plug connection.

Fig 2: Removing Transversal Acceleration Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

If necessary, carry out initial Dynamic Drive operation . See 37 10 001 INITIAL OPERATION WITH TEST RUN OF DYNAMIC DRIVE .