37 14 515 Replacing Rear Left or Right Ride-Height Sensor

WARNING: This page is about a different car, the 2008 BMW 760Li and 2007 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Observe safety instructions for raising the vehicle.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection)! See 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Disconnect plug connection (1).

Release nut (2) and disconnect jointed rod.

Tightening torque 37 14 7AZ . See 37 14 ELECTRIC COMPONENTS .

Release screws (4) and remove ride-height sensor.

Installation:

Sensor lever (3) must point outwards from ride-height sensor.

Tightening torque 37 14 6AZ . See 37 14 ELECTRIC COMPONENTS .

Fig 1: Identifying Rear Ride Height Sensor Plug Connection, Nut & Screws

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Version with ride-height control: Carry out ride-height-calibration . See 37 12 012 CARRY OUT RIDE-HEIGHT-CALIBRATION .
Check headlight adjustment , correct if necessary. See 63 10 004 ADJUSTING HEADLIGHTS .