37 10 005 Removing and Installing/Replacing Vent Hose (From 06/2003) For Active Stabilizer (Front)

WARNING: This page is about a different car, the 2008 BMW 760Li and 2007 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove front assembly underside protection . See 51 47 490 REMOVING AND INSTALLING/REPLACING FRONT UNDERBODY PROTECTION .

Release banjo bolts (2) and remove vent hose (3).

Tightening torque 37 11 2AZ . See 37 11 CONTROL AND SUSPENSION ELEMENTS, FRONT .

Disconnect vent hose (3) from Y-distributor.

Unscrew vent valves (1) from oscillating motor.

Installation:

If necessary, fit new vent valves.

Tightening torque 37 11 1AZ . See 37 11 CONTROL AND SUSPENSION ELEMENTS, FRONT .

Fig 1: Identifying Vent Valves, Banjo Bolts & Vent Hose

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip cover (1) and pull filter out of front axle carrier.

Expose vent hose (2) up to Y-distributor and remove.

Fig 2: Identifying Vent Hose & Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Replacing vent valve:

Screw vent valve (1) fully into oscillating motor and remove plug.

Slide vent hose (2) into vent valve (1) up to second marking (M).

Fig 3: Sliding Vent Hose Into Vent Valve

Courtesy of BMW OF NORTH AMERICA, INC.