12 61 280 Removing and Installing or Replacing Oil Pressure Sensor (N73)
WARNING: This page is about a different car, the 2008 BMW 760Li and 2007 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Scalding hazard!
Only perform this task on an engine that has cooled down.
Installation location:
Cylinder bank 1 to 6 underneath timing chain tensioner.
Engine oil may emerge when oil pressure switch is replaced; have a cleaning cloth ready.
Necessary preliminary tasks:
Switch off ignition.
NOTE:
Illustration does not show exhaust manifold.
Unlock and detach plug connection (1).
Unscrew oil pressure switch (2).
Installation:
For tightening torque, 12 61 1AZ , see 12 61 OIL PRESSURE, OIL TEMPERATURE, OIL LEVEL DISPLAY .
Check engine oil level, top up engine oil if necessary.