LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1284 (Steering And Wheel Alignment - Service Information) >> 32 Steering And Wheel Alignment >> 15. Faults >> 15.3 Rear axle faults

15.3 Rear axle faults

WARNING: This page is about a different car, the 2007 BMW 530xi, 2007 BMW 525xi, 2006 BMW 530xi, and 2006 BMW 525xi. However, it is still accessible from the selected car via links, so may be relevant.
REAR AXLE FAULTS CHART

Fault Cause Remedy
1. Camber deviation a) Vehicle not in normal position: spring deflection too great a) Correct height level
  b) Rubber mount on rear axle carrier defective b) Replace rubber mount
  c) Rear axle carrier deformed c) Check rear axle carrier and replace, if necessary
  d) Control arm deformed d) Check control arm and replace, if necessary
  e) Traction strut deformed e) Check traction strut and replace, if necessary
  f) Distortion in the floor assembly f) Repair body
  g) Swinging arm deformed g) Replace swinging arm
2. Rear wheel position is not correct a) Rear axle carrier has been shifted laterally a) Check the rubber mounts on the rear axle carrier and replace, if necessary
  b) Distortion in the floor assembly b) Repair body
3. Toe deviation a) Vehicle not in normal position, i.e. spring deflection too great a) Correct height level
  b) Rubber mount in rear axle carrier defective b) Replace rubber mount
  c) Control arm deformed c) Replace control arm
  d) Rubber mount and swinging arm defective d) Replace swinging arm
  e) Rear axle carrier deformed e) Check rear axle carrier and replace, if necessary
  f) Traction strut deformed f) Check traction strut and replace, if necessary
4. Deviation from the geometrical drive axis Requirement: Total wheel toe is correct  
  a) Distortion in the floor assembly a) Repair body

Further details on the "Kinematic Diagnosis System" can be found in the operating instructions for the BMW KDS (Beissbarth/Bosch). 

Functional and system descriptions are not subject to change. Parts availability and immediate ordering availability cannot be derived from this information. The specialist departments will be providing further details at the relevant time.