LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (DISC - 745i, 745Li, 760i & 760Li) >> Removal & Installation >> Brake Discs (Front) >> Installation

Brake Discs (Front): Installation

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2005 BMW 760i, 2005 BMW 760Li, 2005 BMW 745i, 2005 BMW 745Li, and 2004 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.
  1. Thoroughly clean contact surface of brake disc at wheel hub. Remove traces of corrosion if necessary. Unevenness on contact surface may result in distortion of brake disc.
  2. Install brake disc and tighten bolts to specification. See TORQUE SPECIFICATIONS .
  3. If removed, replace brake linings. See BRAKE LININGS (FRONT) .
  4. Check that brake hose has not been disconnected. If disconnected, make sure it is positively attached when installed.Tighten to specification. See TORQUE SPECIFICATIONS .
  5. Replace caliper and tighten screws to specification. See TORQUE SPECIFICATIONS .
  6. Install wheels and bleed brakes if brake hose was disconnected. See BLEEDING BRAKE SYSTEM .
scientia non olet · About LEMON Manuals