LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (DISC - 745i, 745Li, 760i & 760Li) >> Bleeding Brake System >> Bleeding Procedures >> Notes

Bleeding Procedures: Notes

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2005 BMW 760i, 2005 BMW 760Li, 2005 BMW 745i, 2005 BMW 745Li, and 2004 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Use only clean brake fluid. Ensure no dirt or other foreign matter contaminates brake fluid. DO NOT mix different brands of brake fluid, as they may not be compatible. DO NOT spill brake fluid on car, as it will damage paint. If brake fluid contacts paint, immediately flush with water.
NOTE: Check relevant operating instructions for each device. Charging pressure should not exceed 29 PSI (2 bar).
  1. Connect BMW Diagnosis and Information System (DIS).
  2. Call up service function for BLEEDING DSC HYDRAULICS.
  3. Connect bleeding unit to expansion tank and switch on.
  4. To flush system completely, see FLUSHING BRAKE SYSTEM COMPLETELY .
  5. To only bleed front or rear system, see BLEEDING FRONT OR REAR-AXLE BRAKE CIRCUIT .
  6. Switch off bleeder unit and disconnect from expansion tank.
  7. Check brake fluid level.
    8. NOTE: Take care of rubber gasket in lid.
  8. Close expansion tank.
scientia non olet · About LEMON Manuals