51 24 Rear Lid Locks
WARNING: This page is about a different car, the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, and 2007 BMW 750Li. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATION - REAR LID LOCKS
| - | Type | Tightening specification | Measure |
|---|---|---|---|
| 1AZ Banjo bolt to hydraulic unit and to hydraulic cylinder | E39 | - | Touring 10+2.5 Nm |
| - | E65/E66/E67 | - | 15 Nm |
| 2AZ Oil filler plug to hydraulic unit | E65/E66/E67/E39 / Touring | - | 8+2 Nm |
| - | E61 | - | 1+0.3 Nm |
| 3AZ Engine bolt to hydraulic unit | E65/E66/E67 | - | 5+1.5 Nm |
| 4AZ Hydraulic unit to bracket | E61 | - | 2+1.5 Nm |
| - | E65/E66/E67 | - | 10 Nm |
| 5AZ Rear lid lock to rear lid | E65/E66/E67/E85/E86 | - | 10 Nm |
| 6AZ Striker to body | E65/E66/E67/E85/E86 | - | 10 Nm |
| 7AZ Bracket, hydraulic unit, to body | E65/E66/E67 | - | 10 Nm |
| 8AZ Bracket, angle sensor, to body | E65/E66/E67 | - | 7 Nm |
| 9AZ Valve to hydraulic unit | E65/E66/E67 | - | 14 Nm |
| 10AZ Ball pin for hydraulic cylinder to body | E61 | Install with Loctite 270 | 41 Nm |