LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1253 (Rear Axle - Tightening Torques) >> 55 Stabilizer Bar >> 33 55 Stabilizer Bar

33 55 Stabilizer Bar

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATION - STABILIZER BAR

- Type Thread Tightening specification Measure
1AZ Stabilizer to trailing arm E30, E31, E36 / Z3 / Compact M8 tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION 22 Nm
- E31 M10 tighten in normal position  42 Nm
2AZ Stabilizer link on anti-roll bar/swinging arm E38 - - 42 Nm
- E39, E52 - - 65 Nm
- E53 - - 100 Nm
- E60, E61, E63, E64 M10 - 65 Nm
- E65, E66, E67 M10 - 58 Nm
- E60, E61, E63, E64, E65, E66, E67 M12 - 100 Nm
3AZ Retaining bracket, stabilizer bar to rear axle support E46, E52, E85 - - 22 Nm
- E53 - - 19 Nm
E60, E61, E63, E64 M8 - - 28 Nm
E65, E66, E67 M10 - - 60 Nm
E83 M8 - - 21 Nm
4AZ Stabilizer link to bracket E46, E85, E86 M8 Replace nut 22 Nm
5AZ Bracket stabilizer link to upper control arm E46, E85, E86 M8 Replace nuts 22 Nm
6AZ Vibration damper to right stabilizer retaining bracket E61 M12 - 100 Nm
7AZ Stabilizer link to stabilizer bar/upper control arm E83 M10 Replace nuts 65 Nm