LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1253 (Rear Axle - Tightening Torques) >> 32 Control Arms and Strut >> 33 32 Control Arms and Struts

33 32 Control Arms and Struts

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATION - CONTROL ARMS AND STRUTS

- Type Thread Tightening specification Measure
1AZ Trailing arm to rear axle carrier E34 (M5) - Replace screw tighten with special tool 33 3 060 and torque wrench Hazet 6291-2CT 55 Nm
- E30, E32, E34, E36 - tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION 67 Nm
- E30, E32, E34, E36 10.9 - 77 Nm
2AZ Trailing arm to console E31 M14 x 1.5 - 127 Nm
3AZ Trailing arm to wheel carrier E31 M18 x 1.5 - 278 Nm
4AZ Traction strut to wheel carrier E31 - Tapered spigot and bore must be free of grease 80 Nm
- E38, E52 - - -
- E39 - Tapered spigot and bore must be free of grease 55 Nm
- E53 - - 56 Nm
- E60, E61, E63, E64, E65, E66, E67 M10 Replace nut 65 Nm
- E60, E63, E64, E65, E66 M12 Replace nut 100 Nm
5AZ Control arm to rear axle support E31 - tighten in normal position  95 Nm
- E38 - tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION 60 Nm
- E39 - tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION with torque wrench Hazet 6290-CT 60 Nm
- E52 - tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION 60 Nm
- E53 - tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION with special tool 32 3 150 and torque wrench Hazet 6291-ICT 59 Nm
- E60, E61, E63, E64, E65, E66, E67 - Replace nut
tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION		 65 Nm
6AZ Support arm to rear axle support E31 M14 x 1.5 - 127 Nm
7AZ Support arm to wheel carrier E31 - - 150 Nm
8AZ Upper control arm to wheel carrier E31 M14 x 1.5 - 127 Nm
- E38, E52 - - 160 Nm
- E39 - - 142 Nm
- E53 - Replace nut 165 Nm
- E60, E61, E63, E64, E65, E66 - Replace nut 175 Nm
- E67 - Replace nut 110 Nm
9AZ Interconnecting link to trailing arm E31 M16 x 1.5 Tapered spigot and bore both free of grease 120 Nm
10AZ Integral arm to upper control arm E31 M14 x 1.5 - 127 Nm
11AZ Upper/lower control arms to trailing arm E36, E46 M12 x 1.5 Replace nut
tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION		 110 Nm
12AZ Trailing arm to console E36, E46 - - 110 Nm
- E83, E85, E86 M12 x 1.5 10.9 - 100 Nm
13AZ Trailing arm console to body E36, E46, E83, E85, E86 - - 77 Nm
14AZ Upper control arm to rear axle carrier E31 M12 x 1.5 tighten in normal position  77 Nm
- E36 M12 10.9 tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION . Always replace antifatigue bolts with combination bolts and washers 77 Nm
- E38, E39, E52 - tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION 110 Nm
- E52 - tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION 110 Nm
- E46, E83, E85, E86 - tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION 77 Nm
- E53, E60, E61, E63, E64 - Replace nut
tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION		 100 Nm
- E65, E66, E67 - Replace nut
tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION		 -
- - - Jointing torque 100 Nm
- - - Torque angle 90°
15AZ Lower control arm to rear axle carrier E36 M12 10.9 tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION
Always replace antifatigue bolts with combination bolts and washers		 77 Nm
- E46, E83, E85, E86 - tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION 77 Nm
16AZ Support bracket on body E21/E30 - - 28 Nm
17AZ Compression strut on body E46, E83 M8 8.8 - 21 Nm
- E30, E32, E34, E36, E85, E86 M8 10.9 - 30 Nm
- E60, E61, E63, E64 M10 10.9 - 48 Nm
- E65, E66, E67 M10 10.9 - 38 Nm
18AZ Auxiliary control arm to trailing arm and rear axle carrier E32, E34 M14 x 1.5 tighten in normal position  127 Nm
19AZ Additional strut on rear axle carrier E32, E34 M12 x 1.5 - 110 Nm
20AZ Swinging arm to rear axle support E38 Front tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION 60 Nm
- E39 Front tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION 58 Nm
- E52 Front tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION 105 Nm
- E53, E60, E61, E63, E64, E65, E66, E67 Front Replace nut
tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION		 100 Nm
- E38 Rear tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION 130 Nm
- E39 Rear M12 tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION 115 Nm
- E39/Touring, Rear M14 tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION 174 Nm
- M5 - position -
- E52 Rear M14 tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION 160 Nm
- E53, E60, E61, E63, E64, E65, E66, E67 Rear M14 Replace nut
tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION		 165 Nm
21AZ Integral link on front wheel carrier E38, E39, E52, E53 - tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION 105 Nm
- E60, E61, E63, E64, E65, E66, E67 - tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION 100 Nm
22AZ Screw connection, swinging arm, integral link, wheel carrier E38 - tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION 236 Nm
- E39, E52 - Replace nut
tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION		 256 Nm
- E53 - Replace nut
tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION		 250 Nm
- E60, E61, E63, E64, E65, E66, E67 - Replace nut
tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION		 240 Nm
23AZ V-strut to tension strut/body E46/M3/M3 CSL - Replace screws -
- - - Jointing torque 59 Nm
- - - Torque angle 90°
24AZ Upper control arm to trailing arm E85, E86 M12 x 1.5 8.8 Replace nut 100 Nm
- E83 M12x1.5 Replace nut 106 Nm
25AZ Lower control arm to trailing arm E85, E86 M12 x 1.5 10.9 Replace nut
tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION		 77 Nm
- E83 M12 x 1.5 10.9 Replace nut
tighten in normal position  See 32 00 ... MOVING VEHICLE INTO NORMAL POSITION		 100 Nm
26AZ Tension strut to compression strut/body E83 M10 - 60 Nm
27AZ Heat shield to compression strut E83 M6 - 5 Nm
28AZ Heat shield to compression strut E65, E66, E67 M8 - 19 Nm
scientia non olet · About LEMON Manuals