72 12 010 Removing And Installing/Replacing Airbag Module On Left Or Right Front Door

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Read and comply with SAFETY REGULATIONS for handling airbag modules and pyrotechnical belt tensioners.

Incorrect handling can activate airbag and cause injury.

Necessary preliminary tasks:

Disconnect battery negative lead
Follow instructions for disconnecting and connecting battery!
REMOVE FRONT DOOR TRIM

Release nuts (1) and remove holder (2).

Installation:

Tightening torque: 72 12 01AZ . See AIRBAG MODULES for specs.

Coat nut and thread with paint (any color and type can be chosen).

Fig 1: Identifying Holder And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Fold back tabs (1) of plastic housing and remove airbag module (2) from airbag mounting.

Fig 2: Removing Airbag Module From Airbag Mounting

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT:

There must be no foreign bodies (e.g. screws, nuts, etc.) in the airbag mounting (1).

Fig 3: Identifying Fold Back Tabs

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slots (2) of holder (1) must be above threaded pins (3).

Point angled part of holder (1) to door trim panel.

Fig 4: Identifying Slots Of Holder And Threaded Pins

Courtesy of BMW OF NORTH AMERICA, INC.