67 65 010 Removing and Installing or Replacing Drive Unit For Roller Sun Blind

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove roller sun blind (refer to Removing and installing/replacing trim for parcel shelf) . See 51 46 000 REMOVING AND INSTALLING/REPLACING TRIM FOR REAR PARCEL SHELF .

Release screw (1).

Remove drive linkage (2).

Mark installation position of servodrive on bracket (3).

Installation:

Ensure correct cable routing.

Fig 1: Identifying Drive Linkage, Bracket & Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Do not damage electrical lead for roller sun blind drive unit when drilling.

Arrange bores according to dimensions (A - D) and release screws underneath for roller sun blind drive unit.

Remove roller sun blind drive unit.

Dimensions from reference line (1):

A = 155 mm

B = 60 mm

C = 60 mm

D = 30 mm

Fig 2: Identifying Bores Arrangement Dimensions

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Drive linkage (2) can only be installed in one position.

Installation:

Install drive linkage (2) and insert screw (1).

Secure drive unit to bracket (3).

Tighten screw (1).

Fig 3: Identifying Drive Linkage, Bracket & Screw

Courtesy of BMW OF NORTH AMERICA, INC.