67 62 000 Removing and Installing/Replacing Flat Motor For Front Left Or Right Power Window

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove function carrier in front door . See 51 21 035 REMOVING AND INSTALLING/REPLACING FUNCTION CARRIER ON LEFT OR RIGHT FRONT DOOR

Unlock plug connection (1) and disconnect.

Release screws (2), tightening torque 51 33 1AZ. See 51 33 POWER WINDOWS, FRONT

Slacken screw (3) on retaining clip.

Press flat motor for power window (4) towards rear out of mounting and feed out in direction of arrow.

Fig 1: Removing Flat Motor For Power Window Out Of Mounting

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure guides (1) are correctly seated when fitting retaining clip (2).

Fig 2: Identifying Guides & Retaining Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Initialize power window. See 67 62 ... NOTES ON INITIALIZING POWER WINDOW