67 61 005 Removing and Installing (Replacing) Drive With Gear For Actuating Slide/Tilt Sunroof

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove front console insert . See 61 31 175 REMOVING AND INSTALLING/REPLACING SWITCH FOR SLIDE/TILT SUNROOF

NOTE: Secure drive with gear for actuating slide/tilt sunroof (2) against falling out.

Release screws (1).

Remove drive with gear for actuating slide/tilt sunroof (2) and disconnect plug connection (3).

Installation:

Replace screws (1).

Fig 1: Removing Drive With Gear For Actuating Slide/Tilt Sunroof & Disconnecting Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert gear wheel (1) of drive for actuating slide/tilt sunroof (2) in gear teeth (3).

Fig 2: Inserting Gear Wheel Of Drive For Actuating Slide/Tilt Sunroof In Gear Teeth

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Initialize drive for actuating slide/tilt sunroof. See 54 0 ... NOTES ON STEEL AND GLASS SLIDE/TILT SUNROOFS (INITIALIZATION/NORMALIZATION/LEARNING OF CHARACTERISTIC CURVE) .

IMPORTANT:

Replacement:

Observe notes and instructions in HLI VK6229. (PuMA measure)

Replacement:

Carry out programming/coding. See VEHICLE PROGRAMMING AND CODING .

IMPORTANT: There is a risk of permanent battery discharge if programming/coding is not carried out!