LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1242 (Electrical Drives - Repair) >> 16 Servo-Positioning Drive >> 67 16 011 Removing and Installing/Replacing Left Headlight Vertical Aim Adjuster (Xenon Headlight)

67 16 011 Removing and Installing/Replacing Left Headlight Vertical Aim Adjuster (Xenon Headlight)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Xenon headlights: Danger to life due to high voltage! Therefore disconnect xenon headlights from the power supply.

Work on the entire xenon lighting system (ignition unit, control unit and lamp) may only be carried out by specialist personnel.

After installation:

Necessary preliminary tasks: 

Release screws (1) and fold down cover cap for headlight vertical aim adjuster (2).

Unlock catch and remove high beam cover cap (3) in direction of arrow.

Fig 1: Removing High Beam Cover Cap
G04769146Courtesy of BMW OF NORTH AMERICA, INC.

Build date up to 03/2005: 

Disconnect plug connection (1) and remove cover cap for headlight vertical aim adjuster (2).

Release screws (3).

Feed out headlight vertical aim adjuster (4) in direction of arrow and remove.

Fig 2: Feeding Out Headlight Vertical Aim Adjuster
G04769147Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Feed ball head (1) of headlight vertical aim adjuster (2) in direction of arrow into mounting (3).

Pass headlight through removed cover cap for low-beam headlight to facilitate the feed-in process. Ball head (1) must audibly snap into place in mounting (3).

Fig 3: Feeding Ball Head Of Headlight Vertical Aim Adjuster Into Mounting
G04769148Courtesy of BMW OF NORTH AMERICA, INC.

Build date from 03/2005: 

Disconnect plug connection (1).

Release screws (2) and slide headlight vertical aim adjuster to left and remove towards rear.

Fig 4: Releasing Joint Seat Nut
G04769149Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Move ignition unit (1) in direction of arrow until mounting (2) approaches opening.

Fig 5: Moving Ignition Unit
G04769150Courtesy of BMW OF NORTH AMERICA, INC.