66 31 001 Adjusting ACC Sensor

WARNING: This page is about a different car, the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, and 2007 BMW 750Li. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

36 1 100
36 1 130

Lever out cap (1).

Using BMW scan tool, carry out adjustment of ACC sensor (2) with special tool 36 1 130 by means of adjusting screws (3). See 36 1 130 T20 WRENCH (TORX)

Fig 1: Identifying Cap, ACC Sensor & Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Special tool required:

Active Cruise Control ACC adjusting device, complete.

Order number: 81 10 0 021 292

Consisting of:

Mirror, complete
Wheel laser
Slotted diaphragm
Control bracket (for initial installation of rail)
Rail
Setup and operating instructions (not shown)

Fig 2: Identifying Mirror, Wheel Laser, Slotted Diaphragm, Control Bracket & Rail
Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: A holder which is not included in the scope of delivery is required to support the wheel laser. Use either the quick - action clamp from the existing KDS or ACC wheel holder (36 1 100 ). See 36 1 100 ACC WHEEL HOLDER

NOTE:

Follow instructions for ACC adjusting device.

NOTE:

To adjust the ACC sensor, connect the BMW diagnosis system and fit the ACC adjusting device.

Select ACC system in diagnosis. Start test module "ACC adjustment" (service functions) and proceed in accordance with instructions.

Handle ACC adjusting device in accordance with mounting and operating instructions provided with device.