LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1240 (Audio, Navigation, Anti-Theft And Restraints - Repair) >> 50 Video and TV Equipment >> 65 50 631 Replacing Control Unit For Rear Compartment Monitor

65 50 631 Replacing Control Unit For Rear Compartment Monitor

WARNING: This page is about a different car, the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, and 2007 BMW 750Li. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks: 

CAUTION:

The fully installed rear compartment monitor can only be swiveled up and down with the ignition turned on. Then turn off ignition again immediately.

Swiveling rear compartment monitor up/down without ignition voltage, refer to removing rear compartment monitor.  See 65 50 120 REMOVING AND INSTALLING/REPLACING REAR COMPARTMENT MONITOR .

NOTE: Follow instructions for handling optical fibers  . See 61 00 ... NOTES ON HANDLING OPTICAL FIBERS

Fold up rear compartment monitor (1).

Release screws (2) and remove trim in center console at rear (3) in direction of arrow.

Fig 1: Removing Trim In Center Console At Rear & Screws
G04769049Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Installation: 

Do not mix up plug connections (3) and (4).

Unlock plug connections (2), (3) and (4) and disconnect.

Feed out control unit for rear compartment monitor (5) in direction of arrow and set down.

Fig 2: Removing Control Unit For Rear Compartment Monitor
G04769050Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connection (1) and disconnect.

Remove control unit for rear compartment monitor (2).

Fig 3: Identifying Plug Connection & Rear Compartment Monitor
G04769051Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: 

Carry out coding/programming.

Observe following IDC specifications: