65 50 011 Removing and Installing (Replacing) Video Module For On-Board Monitor
WARNING: This page is about a different car, the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, and 2007 BMW 750Li. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Disconnect battery negative lead See 12 00 ... INSTRUCTIONS FOR DISCONNECTING AND CONNECTING BATTERY
- Remove flap in luggage compartment panel on left. See 51 47 172 REMOVING AND INSTALLING/REPLACING FLAP IN LUGGAGE COMPARTMENT TRIM, LEFT OR RIGHT
NOTE:
Follow instructions for handling optical fibers
. See 61 00 ... NOTES ON HANDLING OPTICAL FIBERS
Installation:
Do not mix up antenna connectors (1).
Mark antenna plugs (1) and disconnect.
Unlock plug connections (2) and disconnect.
Release screws (3).
Feed out video module for on-board monitor (4) in direction of arrow and remove.
Replacement:
Carry out coding/programming.
Observe following IDC specifications:
- Programming
- Coding
- Car & Key Memory
- CD "CIP"