64 11 826 Replacing Servodrive For Recirculated Air Flaps (Automatic A/C High)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove battery negative lead See 61 20 900 DISCONNECTING AND CONNECTING BATTERY NEGATIVE LEAD
Remove glovebox See 51 16 366 REMOVING AND INSTALLING RIGHT GLOVEBOX WITH HOUSING and/or 51 16 367 REMOVING AND INSTALLING RIGHT GLOVEBOX (WITH ACTIVE KNEE PROTECTOR) WITH HOUSING

Release screw (1).

Detach right footwell air duct (2) in direction of arrow and remove towards bottom.

Fig 1: Detaching Right Footwell Air Duct

G04767292

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fold back fuse box (2) in direction of arrow and place to one side.

Fig 2: Folding Fuse Box

G04768877

Courtesy of BMW OF NORTH AMERICA, INC.

Remove retainer (1).

Unclip linkage (2) in direction of arrow.

Release screw (3) and pull back holder (4) in direction of arrow.

Disconnect plug connection (5) and remove holder (4).

Fig 3: Removing Holder

G04768878

Courtesy of BMW OF NORTH AMERICA, INC.

Press lock (1) and unclip servodrive (2) in direction of arrow from holder (3).

Installation:

If necessary, align shaft of flap(s) to be actuated to position of servodrive to be installed.

Fig 4: Uncliping Servodrive From Holder

G04768879

Courtesy of BMW OF NORTH AMERICA, INC.