63 21 186 Removing And Installing/Replacing Rear Light (On Centre Of Rear Lid)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

Lever out covers (1) at bottom and remove.

Fig 1: Identifying Cover

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE:

Releasing rear light is shown on left side.

Releasing rear light on right side is done in same way.

Unfasten plug connection (1) and disconnect.

Unscrew nuts (2).

Fig 2: Identifying Seat Cover Retaining Points

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE:

Secure rear light against falling out.

Lower luggage compartment lid.

Fig 3: Identifying OC3 Mat And Trim Wires

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE:

If necessary, secure shims under rear light (1) against falling out.

Pull out rear light (1) slightly in direction of arrow.

Disconnect plug connection underneath and remove rear light (1).

Installation:

Make sure gap is uniform all round between rear light (1) and luggage compartment lid (2).

Make sure sealing frame for rear light is correctly seated; REPLACE if necessary.

WARNING:

Follow instructions for HANDLING LIGHT BULBS (EXTERIOR LIGHTS) .

Replacement:

If necessary, remove bulbs.