63 21 183 Removing And Installing/Replacing Left Or Right Rear Light (From 03/2005) (On Rear Lid)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

Read and comply with notes on protection against electrostatic damage (ESD PROTECTION)

Necessary preliminary tasks:

REMOVE REAR TRIM

Detach trim (1) in area (A) of rear light (2) downwards.

Area (B) of trim (1) remains on vehicle.

Installation:

Ensure trim (1) is correctly seated.

Fig 1: Identifying Screws And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Unscrew nuts (2).

NOTE:

Secure rear light against falling out.

Unclip rear light (1) and remove.

Fig 2: Identifying Top Rail, Bottom Rail And Gas Cartridge

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty clip (2).

Make sure there is a uniform gap (outer) all round for rear lid.

Make sure sealing frame for rear light is correctly seated; replace SEALING FRAME if necessary.

Fig 3: Identifying Gas Cartridge And Guide Lug

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

If necessary, remove BULB .