61 61 082 Removing And Installing/Replacing Right Windscreen Wiper Arm (Passenger Side)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 331
61 6 060

IMPORTANT: Risk of damage!
Both windscreen wiper arms are secured with significantly different torques.

Move windscreen wiper system into rest position with diagnosis of "assembly position" service function.

Remove protective cap (1) and cap (2).

Installation:

Make sure protective cap (1) engages correctly.

Fig 1: Identifying Protective Cap And Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Version 1:

Water jet hose (1) connected to distributor

Unlock plug (1) and remove.

IMPORTANT: At low outside temperatures, carefully heat water jet hose (2) in area of distributor with hot air blower.

Detach water jet hose (2) by turning.

Unscrew nuts (3).

Fig 2: Identifying Water Jet Hose, Nuts And Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Type 2:

Water jet hose (1) with gray slide (2) (quick-release coupling)

For releasing, push slide (2) of quick-release coupling forwards until it snaps audibly into place.

Remove hose (1).

Unscrew nuts.

Installation:

Check sealing ring on distributor for damage, replace if necessary.

Fig 3: Identifying Jet Hose And Gray Slide

Courtesy of BMW OF NORTH AMERICA, INC.

To facilitate installation, coat sealing ring with antiseize agent.

For fitting, push slide (2) of quick-release coupling back until it snaps audibly into place. Push water jet hose (1) onto distributor.

Detach wiper arm.

IMPORTANT: Do not bend wiper arm when removing it (risk of breakage).

Use special tool 61 6 060 to detach wiper arms or adjusting disk.

Fig 4: Identifying Special Tool (61 6 060)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

A tightly fit mounting element (1) in wiper arm can be reused.

A loose mounting element (1) must be replaced.

Fig 5: Identifying Mounting Element

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fit mounting disk (1).

Partially screw nuts onto shafts but do not screw down fully yet.

Fig 6: Identifying Mounting Disk

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Positioning windscreen wiper blade:

Position wiper blade above marking (1) on windscreen.
Hold wiper arm in this position and tighten down nuts (2) to tightening torque 61 61 13AZ. See GENERAL ELECTRICAL SYSTEM - TIGHTENING TORQUES .
Adhere to settling time, refer to tightening torque 61 61 13AZ. See GENERAL ELECTRICAL SYSTEM - TIGHTENING TORQUES .
Tighten down nuts (2) again to tightening torque 61 61 13AZ. See GENERAL ELECTRICAL SYSTEM - TIGHTENING TORQUES .

IMPORTANT: Observe tightening specification without fail (risk of detaching).

Fig 7: Identifying Wiper Blade And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Adjust contact angle to windscreen:

Wiper blade must rest above marking (1) on windscreen.
Place special tool 00 9 331 at height of pivot point of wiper blade on windscreen; if there is no light gap: adjust contact angle.

Fig 8: Identifying Wiper Blade And Nuts
Courtesy of BMW OF NORTH AMERICA, INC.