54 12 003 Adjusting Glass Slide/Tilt Sunroof Lid
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
Close glass sunroof lid (zero position).
Ideal adjustment:
- Distance:
- Distance (A) between lid and roof at front and rear must be the same.
- Slide in special tool 00 9 341 between seal and lid. This check (sliding in and pulling out the special tool) must be subject to tightness.
- Height:
- Front - flush to 1 mm deeper
- Rear - flush to 1 mm higher
Adjustment of glass slide/tilt sunroof lid:
Remove GAITER on left and right.
Close sunroof lid again (zero position).
Slacken screws (1) on left/right so that sunroof lid (2) can still just be adjusted.
Height adjustment:
Adjust height of sunroof lid (1) to roof (2) with special tool 00 9 315 (gap wedge).
Press sunroof lid at front and rear up or down until ideal position is reached.
Distance setting:
Slide sunroof lid towards front/rear until ideal position is obtained.
When ideal position is obtained:
- Tighten screws (1)
Tightening torque: 54 12 2AZ . See MECHANICAL SUN ROOF COMPONENTS for specs.
- Check function and adjustment of glass sunroof lid (2).