52 14 400 Replacing Seat Cover For Left or Right Front Seat (Normal/Electric)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

52 0 050

Necessary preliminary tasks:

Remove front seat . See 52 14 000 REMOVING AND INSTALLING LEFT OR RIGHT FRONT SEAT (NORMAL/ELECTRIC)
Remove rear panel on front seat backrest. See 52 14 198 REMOVING AND INSTALLING/REPLACING REAR PANEL ON LEFT OR RIGHT FRONT SEAT BACKREST (NORMAL/ELECTRIC) and/or 52 17 205 REMOVING AND INSTALLING/REPLACING BOTH REAR PANELS ON LEFT OR RIGHT FRONT SEAT BACKREST (COMFORT)
Remove inner cover on front seat

WARNING:

US/CND front passenger seat (with OC3 mat) only:

To avoid damaging the OC3 mat, it is essential to carry out the following operations with extra care.

When replacing seat cover:

If seat cover is defective, seat cover and support with OC3 mat must be replaced together.

New seat cover is supplied with support, OC3 mat and if necessary seat heating.

When replacing support with OC3 mat:

If OC3 mat or support is defective, both parts may only be replaced together.

These must be fitted with the seat cover from the car.

Enabling seat occupancy detector (OC3 mat):

Connect BMW diagnosis system
Release seat occupancy detector
Clear fault memory if necessary

Remove cover (1) on front seat:

Press clip on door side outwards
Press clip on tunnel side upwards
Pull cover (1) forwards out of seat mechanism

Fig 1: Identifying Cover
Courtesy of BMW OF NORTH AMERICA, INC.

Unhook seat cover on at all retaining points (1).

Remove seat cover with support.

If necessary, disconnect all plug connections.

Fig 2: Identifying Seat Cover Retaining Points

Courtesy of BMW OF NORTH AMERICA, INC.

Version with OC3 mat:

OC3 mat must not be kinked under any circumstances.

Detach all retainers in side area from longitudinal wires (1).

Pull trim wires (1) forward out of seat cover.

Carefully fold back seat cover and release retainers from cross - wires (2).

Remove seat cover from support.

IMPORTANT: Remove all remnants of clips from seat cover and support.

Support (1) with OC3 mat (2).

Fig 3: Identifying OC3 Mat & Trim Wires

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT:

No retainer remainders may be fitted as well.

Handle OC3 mat with extreme care.

Do not kink OC3 mat.

Do not clamp OC3 mat.

OC3 mat must lie without folds under seat cover.

Fig 4: Identifying OC3 Mat

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Bend new retainer (2) closed with 52 0 050 PLIERS .

Retainer
Support
Trim thread in support
Trim thread in seat cover
Seat cover

Fig 5: Identifying Retainer, Support, Seat Cover & Trim Thread In Support
Courtesy of BMW OF NORTH AMERICA, INC.

Pull trim threads (1) out of seat cover.

Installation:

Slide trim threads (1) into new seat cover. If necessary, cut mounting for trim threads.

Fig 6: Identifying Trim Threads

Courtesy of BMW OF NORTH AMERICA, INC.