51 45 177 Removing And Installing/Replacing Panel For Active Knee Protector On Left

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2008 BMW 760Li, 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 760Li, and 2007 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

OBSERVE safety regulations for handling airbag modules and pyrotechnical seatbelt tensioners.

Incorrect handling can activate airbag and cause injury.

Follow instructions for disconnecting and connecting battery.

Disconnect battery negative lead.

REMOVE middle instrument panel trim.

REMOVE lighting control unit.

REMOVE trim panel for pedal assembly.

Turn plug connection (1) approx. 30° counterclockwise and remove from holder (2).

Unfasten plug connection (1) and disconnect.

Fig 1: Identifying Plug Connection And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Installation:

Tightening torque: 51 45 1AZ . See TRIM, INSTRUMENT PANEL for specs.

Fig 2: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Installation:

Tightening torque: 51 45 1AZ . See TRIM, INSTRUMENT PANEL for specs.

Remove panel (2).

Fig 3: Identifying Panel

Courtesy of BMW OF NORTH AMERICA, INC.

CAUTION:

Always replace panel for active knee protector on left complete.

Do not carry out any repairs on airbag module.

Installation:

Slide guide (1) of steering column panel into mounting (2).

Fig 4: Identifying Steering Column Panel Guide

Courtesy of BMW OF NORTH AMERICA, INC.