LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1233 (Body Equipment - Repair Instructions) >> 43 Side Covering With Armrests >> 51 43 255 Removing And Installing / Replacing Trim For Rear Left Or Right Roof Pillar (Front)

51 43 255 Removing And Installing / Replacing Trim For Rear Left Or Right Roof Pillar (Front)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2008 BMW 760Li, 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 760Li, and 2007 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Version with head airbag:

FOLLOW  safety instructions for working on cars with airbag systems.

IMPORTANT:

Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Necessary preliminary tasks: 

IMPORTANT:

Lever out expander rivet heads (1) only over groove (3) on lower section (2). If necessary, turn lower section (2) with groove (3) towards front.

Release clip (4) and remove trim (5) towards inside/top.

Fig 1: Identifying Trim, Clip, Lower Section And Rivet Heads
G04768016Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

If necessary, replace defective grommet (1).

Fig 2: Identifying Grommet
G04768017Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

If necessary, replace faulty clip (1).

Bores (2) and insulating mat (4) of trim (3) must not be damaged.

Fig 3: Identifying Bores And Insulating Mat Of Trim
G04768018Courtesy of BMW OF NORTH AMERICA, INC.