51 16 175 Removing And Installing / Replacing Decorative Trims (All) On Function Carrier
Special tools required:
When removing side decorative trims (1) or decorative trim (2) for audio system controller:
Do not under any circumstances place a tool on the dotted lines as this would destroy the decorative trim.
Side decorative trims:
Remove lower storage tray before removing side decorative trims (risk of damage).
Fit protective cover (4) to prevent scratching.
Remove LOWER STORAGE TRAY (DRAWER) from function carrier.
Using special tool 00 9 318 (universal wedge), lever out catches (1) and remove decorative trim (2).
Detach decorative trim (3) in same way.
Installation:
If necessary, replace faulty clips (1) on left/right.
Catches (2) of decorative trim (3) must not be damaged.
Decorative trim for audio system controller:
Remove lower storage tray and side decorative trims before removing decorative trim for audio system controller (risk of damage).
Fit protective cover (2) to prevent scratching.
Open drawer (1).
Using special tool 00 9 318 (universal wedge), lever out catches (4) and remove decorative trim (3).
Installation:
If necessary, replace faulty clips (1) on left/right.
Catches (2) of decorative trim (3) must not be damaged.
Decorative trim on storage tray (drawer):
Remove STORAGE TRAYS (DRAWERS) from function carrier
Decorative trim on bottom drawer:
Using a screwdriver, press pin (2) on left/right out of clip (1).
Lever decorative trim (4) in direction of arrow out of drawer (3).
Installation:
Lever out clips (1) from drawer (2) and replace.
Installation:
Fitting decorative trim (3) on drawer (5):
- Fit groove (2) on mounts (4)
- Press decorative trim (3) downwards
- Snap pins (1) into clips (6)
Installation:
Following parts of decorative trim (3) must not be damaged:
- Release button
- Pins