51 14 110 Removing And Installing/Replacing Rear Model Designation (BMW ALPINA B7)
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2008 BMW 760Li, 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 760Li, and 2007 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
The "INSTRUCTIONS FOR NUMBER/LETTER COMBINATION CEMENTING " serve as the basis for these repair instructions and must be followed without fail.
Stick on top edge of adhesive tape (1) parallel to trim (2) on rear lid at distance (A).
Mark measurement (B) on top edge of adhesive tape (1).
Remove liner (protective strip for adhesive surface).
Position lettering against adhesive tape (1) and press down firmly.
Dimensions:
A = 10 mm
B = 30 mm
Stick on top edge of adhesive tape (1) parallel to trim (2) on rear lid at distance (A).
Mark measurement (B) on top edge of adhesive tape (1).
Remove liner (protective strip for adhesive surface).
Position lettering against adhesive tape (1) and press down firmly.
Dimensions:
A = 10 mm
B = 50 mm