51 11 156 Removing And Installing/Replacing Front Bumper Trim (BMW ALPINA B7)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2008 BMW 760Li, 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 760Li, and 2007 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove both PROTECTIVE STRIPS
Remove BASEPLATE for number/license plate
Remove UNDERBODY PROTECTION .

Remove cover (1) and air duct (2) on left/right.

Fig 1: Identifying Cover And Air Duct

G04767472

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) on left/right.

Release screws (2) on bracket (3) on left/right.

Fig 2: Identifying Bracket And Plug Connection

G04767473

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) or clip (1) on left/right.

Fig 3: Identifying Clip

G04767470

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

IMPORTANT:

Bumper trim must not be pulled out sideways (risk of damage).

Feed out cable for ultrasonic transducer and, with a 2nd person helping, remove bumper trim (2) towards front.

Installation:

Observe gap dimensions.

Fig 4: Identifying Bumper Trim

G04767475

Courtesy of BMW OF NORTH AMERICA, INC.