51 11 ... Fitting Front Spoiler (BMW ALPINA B7)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2008 BMW 760Li, 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 760Li, and 2007 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Bumper trim (1) can already by supplied cut to size.

Cut uncut bumper trim (1) to dimensions (A to G).

A = 85 mm

B = 600 mm

C= 45 mm

D= 250 mm

E = 145 mm

F = 60 mm

G = 50 mm

Place front spoiler on cut bumper trim and check for accuracy of fit; if necessary, rework bumper trim.

Fig 1: Identifying Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Remove cover from towing eye.

Grind off ridges (1) flat with bumper trim (2).

Fig 2: Identifying Ridges And Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Clean adhesive area of bumper trim with spirit.

Lay out clamp or screw clamp ready.

NOTE:

The operation is shown on the right side; proceed in the same way for the left side.

Pull off complete liner (1).

Pull off liner (2) approx. 60 mm only at start and secure with adhesive tape to inside of front spoiler.

Pull off liner (3) approx. 60 mm only at start and secure with adhesive tape to outside of front spoiler.

Clean front spoiler in areas (A and B) with spirit.

For application of adhesive in areas (A and B), see next work step.

Fig 3: Identifying Liners

Courtesy of BMW OF NORTH AMERICA, INC.

Apply adhesive bead (1 and 2) dia. = 5 mm in area (A and B).

A = Cutout, towing eye

B = Side between adhesive tapes

Fig 4: Identifying Adhesive Bead

Courtesy of BMW OF NORTH AMERICA, INC.

Place front spoiler (1) over towing eye cutout (3) on bumper trim (2), align and stick on.

Front spoiler (1) must be seated flush with bumper trim (2).

Gap (A) in area of towing eye area (3) must be the same on both sides.

Secure front spoiler (1) in adhesive area with clamp/screw clamp to bumper trim (2).

NOTE:

Fit protection between clamp/screw clamp and painted surfaces.

Remove emerging adhesive immediately.

NOTE:

First feed bonding from towing eye cutout to right.

Then repeat procedure to left.

Fig 5: Identifying Front Spoiler And Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Pull off liner (3) from adhesive tapes on inside and outside in approx. 100 mm increments and simultaneously press front spoiler (1) down on bumper trim (2).

Front spoiler (1) must rest in area (A) without gaps on bumper trim (2).

Secure front spoiler (1) in adhesive area with clamp/screw clamp to bumper trim (3).

NOTE:

Fit protection between clamp/screw clamp and painted surfaces.

Fig 6: Identifying Bumper Trim, Front Spoiler And Liner

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE:

Set down bumper trim without tension.

Allow adhesive to set for 24 hours at min. 15°C.

Mechanical strain permitted after no shorter than 2 days (e.g. car wash).