37 20 505 Removing and Installing/Replacing DYNAMIC DRIVE Holder/Valve Block
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Seal off pipe connections with plugs.
After installation:
- Fill and bleed hydraulic system See 32 13 006 BLEEDING POWER STEERING (VERSION WITH DYNAMIC DRIVE)
- Check pipe connections for leaks
- If necessary, carry out initial operation for Dynamic Drive See 37 10 001 INITIAL OPERATION WITH TEST RUN OF DYNAMIC DRIVE
Necessary preliminary tasks:
- Remove valve block . See 37 20 001 REMOVING AND INSTALLING/REPLACING DYNAMIC DRIVE VALVE BLOCK
Release screws (1).
Tightening torque 37 14 20AZ . See 37 14 ELECTRIC COMPONENTS
Take off holder (2).