37 14 515 Replacing Rear Left Or Right Ride-Height Sensor
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe safety instructions for raising the vehicle.
Read and comply with notes on protection against electrostatic damage (ESD protection)! See 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)
Disconnect plug connection (1).
Release nut (2) and disconnect jointed rod.
Tightening torque 37 14 7AZ . See 37 14 ELECTRIC COMPONENTS
Release screws (4) and remove ride-height sensor.
Installation:
Sensor lever (3) must point outwards from ride-height sensor.
Tightening torque 37 14 6AZ . See 37 14 ELECTRIC COMPONENTS
After installation:
- Version with ride-height control: Carry out ride-height-calibration See 37 12 012 CARRY OUT RIDE-HEIGHT-CALIBRATION
- Check headlight adjustment , correct if necessary. See 63 10 004 ADJUSTING HEADLIGHTS