35 11 000 Removing And Installing Mounting Block For Pedals

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

Check the function after installation.

REMOVE PANEL FOR PEDAL ASSEMBLY .

Release screw (1) on footwell air duct. First pull footwell air duct to left, then remove towards bottom front.

Fig 1: Removing Panel For Pedal Assembly

G04767173

Courtesy of BMW OF NORTH AMERICA, INC.

Detach retaining clip on brake pedal (1).

Withdraw pin.

Release nuts (2).

Installation:

Replace nuts (2).

Tightening torque: 35 11 1AZ . See PEDAL ASSEMBLY CONSOLE for specs.

Fig 2: Identifying Retaining Clip On Brake Pedal

G04767125

Courtesy of BMW OF NORTH AMERICA, INC.

REMOVE BRAKE LIGHT SWITCH (1) .

Release nut (2) for brake pedal.

Installation:

Replace nut (2).

Tightening torque: 35 11 1AZ . See PEDAL ASSEMBLY CONSOLE for specs.

Fig 3: Identifying Brake Light Switch And Nut

G04767175

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws (1).

Pull out light module with holder towards front.

Pull off connectors.

Remove light module.

Remove bearing bracket for pedal assembly.

Fig 4: Pulling Connectors

G04767176

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Position guide lug (1) precisely during installation to prevent damage.

Fig 5: Identifying Guide Lug

G04767177

Courtesy of BMW OF NORTH AMERICA, INC.