34 52 550 Removing and Installing/Replacing DSC Yaw Sensor (DSC Sensor)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD protection)
. See 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)
Necessary preliminary tasks:
- Remove right front seat See 52 14 000 REMOVING AND INSTALLING LEFT OR RIGHT FRONT SEAT (NORMAL/ELECTRIC) and/or 52 17 000 REMOVING AND INSTALLING LEFT OR RIGHT FRONT SEAT (COMFORT)
- Remove front inside entrance cover strip See 51 47 000 REMOVING AND INSTALLING/REPLACING ENTRANCE COVER STRIP, FRONT (INSIDE) LEFT OR RIGHT
NOTE:
The yaw sensor comprises the function of the transversal acceleration sensor and the yaw sensor.
Lift floor carpet and fold back to one side.
IMPORTANT:
Do not kink floor panelling under any circumstances!
Remove expansion rivets (1).
Carefully raise air duct at rear and turn to one side.
Disconnect plug connection.
Release screws (1) and remove rotation rate sensor.
Installation:
Tightening torque 34 51 3AZ. See 34 51 SLIP CONTROL SYSTEM (ABS, ASC+T, DSC)
Ensure proper locking of plug connector.