33 21 035 Replacing Gaiter On Left Output Shaft

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

21 2 120
26 1 110
33 2 100

Necessary preliminary tasks:

Remove output shaft . See 33 21 001 REMOVING AND INSTALLING/REPLACING LEFT OUTPUT SHAFT or 33 21 002 REMOVING AND INSTALLING/REPLACING RIGHT OUTPUT SHAFT .

Clean output shaft.

Press off sealing cap (1).

Installation:

Press on sealing cap with a thrust ring

Coat sealing faces of sealing cap with sealing compound (refer to BMW Parts Service).

Fig 1: Identifying Sealing Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten hose clip (2).

Press cap (3) off together with gaiter.

Remove circlip (4).

Installation:

Turn new gaiter with cap (3) so that fastener of large hose clamp is between two bores of constant-velocity joint.

Fig 2: Identifying Hose Clip And Circlip

Courtesy of BMW OF NORTH AMERICA, INC.

Special tool 26 1 110 must be used in accordance with diameter of output shaft. Bearing inner race must rest on rib of special tool.

Hollow shaft only: Also use special tool 21 2 120.

Press splined shaft out of constant-velocity joint.

Clean constant-velocity joint carefully and remove all traces of old grease.

Check constant-velocity joint for damage, replace if necessary.

Detach gaiter from splined shaft.

Fig 3: Identifying Special Tool (21 2 120) And (26 1 110)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Pull gaiter onto cap (3).

Coat sealing surface of cap (3) with sealing compound (refer to BMW Parts Service) and press with a thrust ring onto constant - velocity joint.

Fill constant-velocity joint with high-temperature grease (refer to BMW Parts Service).

Install new circlip.

Press constant-velocity joint and cap (3) over inner bearing race on splined shaft.

Mount special tool 33 2 100 with corresponding insert.

Push new gaiter onto splined shaft.

Fig 4: Identifying Special Tool (32 2 100)

Courtesy of BMW OF NORTH AMERICA, INC.

Release hose clamps (5, 6).

Detach gaiter from splined shaft.

Clean joint carefully and remove all traces of old grease.

Installation:

Pull new gaiter on.

Thoroughly clean joint while assembled and remove old grease completely.

Fig 5: Releasing Hose Clamps

Courtesy of BMW OF NORTH AMERICA, INC.

Disassembling/assembling constant-velocity joint:

NOTE: Mark positions of ball hub, ball cage and joint with respect to each other with electric inscriber.
Ensure all parts are clean prior to assembly.

Fig 6: Identifying Mark Positions Of Ball Hub

Courtesy of BMW OF NORTH AMERICA, INC.