33 17 004 Replacing All Front Rubber Mounts For Rear Differential Mounting

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

33 3 312
33 3 314
33 3 315
33 4 162
33 4 164
33 4 165
33 4 166

IMPORTANT: Observe safety when raising the vehicle.

Necessary preliminary tasks:

Remove rear differential . See 33 10 010 REMOVING AND INSTALLING/REPLACING REAR DIFFERENTIAL .

Withdraw front rubber mount with special tools 33 3 312 , 33 4 165 , 33 4 162 , 33 3 315 and 33 3 314.

NOTE: Milled recess of special tool 33 4 165 must rest at top on rear axle carrier.

Fig 1: Removing Front Rubber Mount Using Special Tools (33 3 312), (33 4 162) And (33 3 315)

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Coat bearing bushing in rear axle carrier and new rubber mount with Circolight (refer to BMW Parts Service).

Align rubber mount by way of slots (1) to vehicle transversal direction.

Fig 2: Identifying Rubber Mount With Way Of Slots

Courtesy of BMW OF NORTH AMERICA, INC.

Insert rubber mount from side with larger diameter into special tool 33 4 165.

NOTE: Milled recess (1) of special tool 33 4 165 must rest at top on rear axle carrier.

Fig 3: Inserting Rubber Mount From Side With Larger Diameter Into Special Tool (33 4 165)

Courtesy of BMW OF NORTH AMERICA, INC.

Draw in rubber mount with special tools 33 3 314 , 33 3 315 , 33 4 166 , 33 4 165 and 33 4 164 as far as it will go. Make sure special tool 33 4 166 is correctly seated.

NOTE: Rubber mount must be seated flush in rear axle carrier. If necessary, rotate special tool 33 4 164 through 90° and draw in overlap.

Fig 4: Identifying Special Tool (33 4 166), (33 4 165) And (33 3 314)

Courtesy of BMW OF NORTH AMERICA, INC.