32 41 250 Removing And Installing/Replacing Fluid Reservoir For Power Steering

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

32 1 260

IMPORTANT: Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Seal off pipe connections with plugs.

Necessary preliminary tasks:

Draw off and dispose of hydraulic fluid from fluid reservoir
M54, N52: Remove gaiter with resonator
M67, M67TU: Release coolant expansion tank and place to one side. See.
N62, N62TU: Remove design cover (left & middle).

Release screw (1).

Tightening torque 32 41 9AZ . See STEERING AND WHEEL ALIGNMENT - TIGHTENING TORQUES .

NOTE: If necessary, raise and/or turn fluid reservoir in order to gain better access to hose clamps.

Remove hose clamps if necessary with special tool 32 1 260 .

Disconnect suction line and radiator return line from fluid reservoir.

Lift out fluid reservoir.

Fig 1: Identifying Hose Clamp Screw

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Fill and bleed hydraulic system . See 32 13 006 BLEEDING POWER STEERING (VERSION WITH DYNAMIC DRIVE) or 32 13 006 BLEEDING POWER STEERING UNIT .
Check pipe connections for leaks