32 41 100 Removing And Installing/Replacing Belt Pulley On Vane Pump For Power Steering
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Carry out preliminary work as described in 11 28 010 REPLACING ALTERNATOR DRIVE BELT (N62/N62TU)
.
Slacken screws (1)
Relieve tension on drive belt and remove from belt pulley (2).
Unscrew bolts (1) and remove belt pulley (2).
Installation:
Lettering on belt pulley (2) must point forwards.
Tightening torque 32 41 14AZ . See STEERING AND WHEEL ALIGNMENT - TIGHTENING TORQUES .