32 41 061 Replacing Power Steering Vane Pump
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Seal off pipe connections with plugs.
Seal off pipe connections with plugs.
After installation:
- Fill and bleed hydraulic system . See 32 13 006 BLEEDING POWER STEERING (VERSION WITH DYNAMIC DRIVE) or 32 13 006 BLEEDING POWER STEERING UNIT .
- Check pipe connections for leaks
- Version with Dynamic Drive: If necessary, carry out initial operation for Dynamic Drive . See 37 10 001 INITIAL OPERATION WITH TEST RUN OF DYNAMIC DRIVE .
Necessary preliminary tasks:
- Check function of vane pump.
- Remove vane pump . See 32 41 037 REMOVING AND INSTALLING POWER STEERING PUMP (N62, N62TU) FOR POWER STEERING GEAR WITH DYNAMIC DRIVE (FROM 10/2003) or 32 41 060 REMOVING AND INSTALLING VANE PUMP (N62, N62TU) FOR POWER STEERING (FROM 10/2003) .
Release screws (1).
Tightening torque 32 41 14AZ . See STEERING AND WHEEL ALIGNMENT - TIGHTENING TORQUES .
Remove belt pulley (2).
Installation:
Lettering on belt pulley (2) points forwards.