31 12 138 Replacing Rubber Mounts On Both Tension Struts

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

31 3 031
31 3 032

IMPORTANT: The rubber mounts on both tension struts must be replaced! Note that the rubber mounts may only be changed once.

Necessary preliminary tasks:

Check ball joints of tension struts while installed, replace tension struts if necessary. See 31 12 080 REMOVING AND INSTALLING/REPLACING BOTH TENSION STRUTS .
Remove tension struts . See 31 12 080 REMOVING AND INSTALLING/REPLACING BOTH TENSION STRUTS .

IMPORTANT: If the tension struts already feature an identification mark with a center punch, it is necessary to replace both tension struts.

Mark tension struts with a punch mark in area (A).

Fig 1: Identifying Punch Mark Area

Courtesy of BMW OF NORTH AMERICA, INC.

Using a press and special tools 31 3 031 and 31 3 032 , press rubber mount out of tension strut.

NOTE: Special tool 31 3 031 must be exactly flush with rubber mount bushing.

Fig 2: Identifying Special Tool (31 3 031) And (31 3 032)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Keep rubber mount and bushing in tension strut clean and free from grease.

Align rubber mount by way of arrow to marking on tension strut and press in. The deviation must not exceed ± 5°.

Fig 3: Aligning Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Protrusion (A) equally large.

Fig 4: Identifying Protrusion

Courtesy of BMW OF NORTH AMERICA, INC.