37 20 505 Removing And Installing/Replacing Dynamic Drive Holder/Valve Block
WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Seal off pipe connections with plugs.
After installation:
- Fill and bleed HYDRAULIC SYSTEM
- Check pipe connections for leaks
- If necessary, carry out initial DYNAMIC DRIVE operation
Necessary preliminary tasks:
- Remove VALVE BLOCK
Release screws (1).
Tightening torque 37 14 20AZ . See ELECTRICAL COMPONENTS for specs.
Take off holder (2).