37 14 512 Replacing Rear Ride-Height Sensor

WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Release nut and disconnect jointed rod (3).

Installation:

Replace self-locking nut.

Tightening torque 37 14 7AZ . See ELECTRICAL COMPONENTS for specs.

Release screws (1).

Tightening torque 37 14 6AZ . See ELECTRICAL COMPONENTS for specs.

Disconnect plug connection (4) and remove ride-height sensor.

Installation:

Sensor lever (2) must point outwards from ride-height sensor.

Fig 1: Identifying Plug Connection And Ride-Height Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

E61: Carry out ride-height-calibration
Check HEADLIGHT ADJUSTMENT , correct if necessary