33 55 021 Replacing Both Rubber Mounts For Stabilizer Mounting
WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
E61: If necessary, remove vibration damper from right retaining bracket of stabilizer.
Tightening torque: 33 55 6AZ . See STABILIZER BAR for specs.
Release nuts (1) on both sides.
Tightening torque: 33 55 3AZ . See STABILIZER BAR for specs.
Turn stabilizer in downwards direction.
Remove retaining bracket (2) on both sides.
Remove rubber mount (3) on both sides.
Installation:
Keep retaining bracket (2), rubber mount (3) and stabilizer if necessary clean and free from oil and grease.
Version with Dynamic Drive: Keep contact face for rubber mount on anti-friction bearing clean and free from oil and grease.