33 33 001 Replacing Left Or Right Rear Axle Carrier Compression Strut
WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe safety instructions for raising the vehicle
Driving without tension and compression struts is not permitted!
Risk of damage!
The rear axle carrier must be supported at the front if both compression struts have to be replaced!
Necessary preliminary tasks:
- If necessary, remove rear tension strut
- Remove tank cover
- Version with Dynamic Drive: Disconnect PRESSURE LINES FOR OSCILLATING MOTOR OF REAR AXLE from tension strut.
Release screws (2).
Tightening torque: 33 32 17AZ . See CONTROL ARMS AND STRUTS for specs.
Release bolt (1) and remove compression strut.
Secure rear axle carrier by inserting bolt (1).
Installation:
Check threads for damage; if necessary, repair with HELICOIL THREAD INSERTS .
Tightening torque: 33 33 3AZ . See REAR AXLE SUSPENSION for specs.